Round one sided 11.75"x11.75"   Door hanger Comes with string to hang

1. Cover the bottom table of the press with a sheet of protective paper.
2. Place substrate face down on bottom table, cover with protective paper, and pre-press for 20 seconds. Do not skip this step. After cooling, dry any remaining moisture on the hardboard.
3. Secure transfer to substrate using ProSpray or Heat Tape.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5.Top with protective paper and press according to time, temperature, and pressure above.

Application note: Should substrate warp or buckle after pressing, weight the substrate while cooling.

This is the suggested time and temp, that I use  everyone’s press is a little different, some run hot some run cool so this don't work with everyone.

Time: 1 minute 20 seconds
Temperature: 400
Pressure: Medium